Your decal should be applied as soon as possible to prevent application issues. Car decals should be applied only to surfaces with temperatures between 50 to 90 degrees Fahrenheit and should be allowed to cure for 24 hours before getting wet. Your decal comes with transfer tape applied to help you easily install it.


What you’ll need:

  • One of our Vinyl Decals
  • Cleaner such as rubbing alcohol (never apply directly on vinyl!)
  • Cloth or Paper Towel
  • Vinyl applicator or an old Credit Card


Each decal has 3 layers:

1. The top layer is the transfer tape

2. The middle layer is the vinyl decal

3. The bottom layer is the backing paper


Installation Tips:

  • Do not apply in cold weather, adhesive may stick but will lift easily.
  • Do not apply in extreme heat, apply in the shade, vinyl will get very soft and stretch in extreme heat.
  • Do not use alcohol to apply, it will destroy the adhesive.
  • Do not use an ice scraper on the decal, it may lift or break pieces off.
  • Do not touch the adhesive backing, oils from your skin will prevent sticking.
  • Do not point high pressure car wash nozzle at the edges of the decal for a long time, may lift or break pieces. Car washes are safe.
  • Before application make sure there is no wax or Rain-X products on the surface, adhesive may stick but will lift easily.
  • Don't apply wax over graphics, especially if the wax contains any petroleum distillates.
  • When using squeegee / credit cards on decal after transfer tape is removed, place squeegee / credit cards inside sock and then squeegee decal. (This will prevent scratching the decal)


1) Clean the surface where you will apply the decal with rubbing alcohol and a cotton ball. Allow it to dry.


2) Beginning in a corner, peel the backing paper off of the transfer tape.


3) Place one side of the transfer tape onto the surface and press it down with the vinyl applicator.


4) Continue applying the decal in a rolling motion using the vinyl applicator to press it down as you go.


5) Once the decal is placed, use the vinyl applicator and rub it firmly from the center point to the edges in all directions to remove air bubbles.


6) Beginning in a corner, slowly peel away the transfer tape at a 45-degree angle.